[Guest]

that is definitely not good! How much does a signal board usually run? I think that this may be the problem as I am getting no power to the tubes......

Also, where would I be able to find one of these?

Thanks again so much for the help....

[minnie]

The only board assemblies left for this model is the small signal board. All others seem to be NLA.

[Guest]

Model # is 8P6044 C101. I called the technician today and he said he had no idea what could be wrong. Guess he'll make it out here eventually but he does seem to be a little slow getting out here. If I had audio but no picture it would be the power board because the tubes aren't lighting up correct?

I'm just going on what I can conjecture and since I can't seem to get the guy over here I thought I'd ask here since everone is so helpful........

[minnie]

Which board? Power? Signal? Deflection? I still don't know why your not calling who ever serviced the unit back. That's why you get a warranty. Plus a model # would be useful.

[Guest]

I was wondering how much (ballpark) a new circuit board would run me for a Phillips 60' rear projection TV. I have audio and no picture and am assuming that I need to have a circuit board replaced. This is due to a possible glycerol spill when the technician re-installed the blue gun whos fluid he changed out and replaced.

Assuming it is the circuit board due to this reason, how much does something like this run? I have also summised that I may simply need a new power supply, which I am told runs at least $70. Please share your thoughts and thanks for the help!