| Author |
Message |
| minnie |
 Posted: Thu Feb 22, 2007 12:33 am Post subject: |
|
| Put the old chip back in, go into the service menu, write down all default values, put new back in transfer values. |
|
 |
| orye |
| Posted: Wed Feb 21, 2007 9:54 pm Post subject: Re: akira tv play black and white |
|
| minnie wrote: |
| orye wrote: |
| akira tv play black and white after replacing 24c08,, is there a service mode code? |
Was the cap polarity sensitive? As in one side has a gray or a white mark denoting the negative side? If yes did you put in correctly. |
all akira tv play black and white when i replace a new memory i.c 24c08. but when i replace with one that i remove in a good working akira tv it play ok. i have this problem with akira tv only. i dont know if i have to enter the service mode to set the new i.c 24c08 |
|
|
| orye |
| Posted: Wed Feb 21, 2007 9:49 pm Post subject: |
|
| Frank wrote: |
| Check your solder work and spills. |
all akira tv play black and white when i replace a new memory i.c 24c08. but when i replace with one that i remove in a good working akira tv it play ok. i have this problem with akira tv only. i dont know if i have to enter the service mode to set the new i.c 24c08 |
|
|
| minnie |
| Posted: Fri Feb 09, 2007 11:43 pm Post subject: Re: akira tv play black and white |
|
| orye wrote: |
| akira tv play black and white after replacing 24c08,, is there a service mode code? |
Was the cap polarity sensitive? As in one side has a gray or a white mark denoting the negative side? If yes did you put in correctly. |
|
|
| Frank |
| Posted: Fri Feb 09, 2007 12:23 am Post subject: |
|
| Check your solder work and spills. |
|
|
| orye |
| Posted: Thu Feb 08, 2007 8:43 pm Post subject: akira tv play black and white |
|
| akira tv play black and white after replacing 24c08,, is there a service mode code? |
|
|