| Author |
Message |
| ekilpatrick1 |
 Posted: Sat Apr 28, 2007 11:54 pm Post subject: Damn!! |
|
| I'm Screwed then!! |
|
 |
| absorbentgnome |
| Posted: Sun Aug 28, 2005 9:55 pm Post subject: |
|
Protect mode occurs when an overcurrent situation is detected by the power supply in the amplifier. This will occur if you have shorted the speaker outputs, or if the amplifier is damaged or has failed.
If protect mode occurs without any connections to your speakers, then the amp is likely damaged. It is possible to repair if you have knowledge of electronics - if not you will have to take it to be repaired. |
|
|
| Guest |
| Posted: Fri Aug 26, 2005 9:34 am Post subject: |
|
| i have the same issue, what did you do or find out? |
|
|
| Jan |
| Posted: Sun Jan 16, 2005 1:46 am Post subject: So sorry about the double post :( |
|
| I'd delete it if I could! |
|
|
| Jan |
| Posted: Sat Jan 15, 2005 10:08 pm Post subject: TEAC AG-V8525 keeps flashing "PROTECT" |
|
Anything I can do about this?
Thanks for any ideas![/code] |
|
|