 Posted: Thu Mar 29, 2007 2:40 am Post subject: |
|
| i hope you did not use cheap aftermarket ics.if so replace again with originals and also check all resistors.especially off red convergence yoke plug.as long as you didnt go into service mode and mess with settings you should be fine.and dont forget heatsinc compound on back of ics.stk392-110. | |
| Posted: Thu Mar 29, 2007 1:56 am Post subject: Jvc AV 56 WP 74 no left or right movement with the red conve |
|
| I replaced the IC's see earlier post here
[url]http://forum.eserviceinfo.com/viewtopic.php?t=23014&highlight=jvc [/url] This did fix my first problem however after the snap crackle pop of one of the resisters going to ____( witch has been replaced ). I cant move the lines in the RED grid left or right but I can move them up and down. The picher doesn't look bad now because I just moved the green and blue to the red. But I would like it to be right so what do you think I fried now? May be the new IC's is all that I can think of. Thank Ray |
|