| Author |
Message |
| cory |
 Posted: Mon Sep 03, 2007 12:19 am Post subject: |
|
| you dont need to discharge to replace convergence ics.but make sure you check small value resistors by yoke connectos,near heatsincs for either 1 or 2 open resistors. |
|
 |
| minnie |
| Posted: Sat Sep 01, 2007 5:06 pm Post subject: |
|
Come on, give the old girl life again!!!  |
|
|
| rsfusion77 |
| Posted: Sat Sep 01, 2007 3:55 pm Post subject: discharge |
|
Its been a few days since you posted this; anyway if you haven't fixed it yet,
I can say that in this circuit, I don't think its necessary to discharge these caps. In contrast to working around the primary side of the smps where discharging the filter cap, is advisable. |
|
|
| danc |
| Posted: Wed Aug 29, 2007 11:47 pm Post subject: changing out 2 convergence ics in hitachi 43FDX10B |
|
| If I have the set unplugged, is there stored energy anywhere? Do I need to discharge the energy or can I just remove the screws slide the panel back and remove the 2 STK392-120s ?? |
|
|