| Author |
Message |
| Guest |
 Posted: Sat Sep 29, 2007 6:45 pm Post subject: |
|
Thanks cory,  I will do that. I got the IC new (hybrid) from partstore.com item # C5AA00000203 and I will attempt to install this afternoon. I haven't done anysoldering for about 10 years but I can probably do it! Mack. |
|
 |
| cory |
| Posted: Sat Sep 29, 2007 5:46 pm Post subject: |
|
| the ics should be stk392-110.you need to unsolder the pins of each ic,on the underside of board.then remove 2 screws then remove ics.remember to apply heatsinc compound to the back of ics,and re-intstall ics and solder pins back.ps.....check all resistors nearby,small value to ensure they havent gone open or burnt up. |
|
|
| minnie |
| Posted: Sat Sep 29, 2007 2:49 pm Post subject: |
|
| Model #? |
|
|
| mackster |
| Posted: Sat Sep 29, 2007 7:26 am Post subject: panasonic convergence removal and installation??????? |
|
 O.K. so I'm retarded! I order IC form a parts store they arrived today and I was hoping for a how to instructions. I got none! they look like they just go press in but I can not get the old ones out. The part number is STK392-100 and they are going into a Panasonic projection TV HOW do I remove these? please help as I love my TV and can't live without her!!!!!  |
|
|