Electronic equipment repair and service manual search discussion :: Topic review - Looking for Stabilock 4040 radio test sets

torbjorn · Posted: Sun Mar 08, 2015 9:12 pm Post subject:

I think the most likely problem is the backup battery on the CPU board, it may leak and cause corrosion or leakage current problems.

Another common problem is all small electrolytic capacitors, they are usually in bad condition if they haven't been replaced before. Particularly in instruments that have been used in a production line, switched on 24/7 for many years. The dark red "ERO" capacitors seem to be of better quality than the smaller black ones. Usually, the electrolytics are in worse condition in the screened modules than on the open PCBs, as the screened modules run hotter.
A few of the electrolytics should best be replaced with low-ESR parts, but i don't have the list of critical positions on hand for the moment.
The big electrolytics in the power supply seldom cause any problems. But please note that the filter capacitors on the outputs from the four step-down converters (four caps for each voltage) may fail with short circuit. In this case, it is easiest to replace all caps for that voltage as they must anyway be desoldered for measurement.

A common problem in the power supply is the flat blade connectors on the bridge rectifier, those connectors are often badly crimped to the wires. It is better to cut off the connectors and solder the wires to the rectifier.

dk3he · Posted: Sat Mar 07, 2015 9:22 pm Post subject: My 4040 has following problem

Hallo Thorbjörn (OR ANYBODY ELSE),

I saw you were looking for a stabilock 4040 test set, even in damaged condition.
May I assume that you have some kowledge about that set?

My 4040 has following problem:
after power ON it beeps permanently, it does not enter initialization, all Displays show strange figures (fixed, and always the same). It does not react to any push button.

Do you have any hint for me where to look?

Thank you,
Eberhard. [email protected]

[email protected] · Posted: Wed May 19, 2010 6:29 pm Post subject: Available Stabilock 4040 Test Set

I do have a test set which I would like to part with. It does not have a current calibration.Let me know if your are still in need.
Thanks
Stalin

torbjorn · Posted: Tue Jun 17, 2008 8:19 am Post subject:

Just a pity that i was not able to follow the auction, and that it was in the US. Well, there will certainly come more occasions...

saw1970_97

There is one for sale here, not mine,
http://electronics.jeep.elementfx.com/
Price was at 51.00 when I looked.

minnie

Guest · Posted: Wed Apr 23, 2008 1:04 am Post subject: stabilock 4040 in North America

I have one - unit has not been calibrated since the late 80's...

torbjorn

Anyone who knows of a Stabilock 4040 that might be for sale, preferrably in northern Europe? It doesn't matter if the instrument is defective or even badly damaged or incomplete, as far as the price is fair.