 Posted: Tue Sep 23, 2008 6:48 pm Post subject: |
|
| Kinda remember having to do reverse engineering to draw schematic on some of them....Most if not all the Promedia's were generally designated factory service only & seem to remember Klipsch support was ok at times. You have a much better chance for a response by posting here (even post a pix) or email Klipsch direct--you just may get lucky.
http://forums.klipsch.com/forums/11.aspx Or may be contact one of these guys on this page & see they might have some info on the 5.1? |
|
| Posted: Tue Sep 23, 2008 11:37 am Post subject: Klipsch |
|
| I contacted him and he doesn't have any klipsch schematics. Does anyone know of anyone else who might have schematics? | |
| Posted: Tue Sep 23, 2008 4:23 am Post subject: wukfhk |
|
| Contact Paul at [email protected]. He can get you the schematic. | |
| Posted: Tue Sep 23, 2008 1:16 am Post subject: klipsch Promedia 5.1 schematics |
|
| I have read all the forums on Klipsch and other related sites. I found quite a few burnt components. Particularly R527, the two diodes next to it.
R529 and the resistor next to it. Does anyone know where I can find schematics or has anyone drawn any up that I could look at. The leads of U501 and U502 are a light brown. Should those be replaced as well? Does anyone know the values of R529 or the other resistor next to it. I have scoured the web and can't find any info on that. Any help would be appreciated. |
|