Electronic equipment repair and service manual search discussion :: Topic review - Mitsu WD-62825

zee · Posted: Tue Dec 09, 2008 6:40 pm Post subject:

thanks for your quick reply. I have another question? do i need to remove also the unit that has all input connection ( right side ) + how do i even remove the metal case? I got the HDD out but, can't get to metal case. how many screws holding the unit? do I slide it out or, pull it up?
i took some picture hopefully the link will work. or just copy & paste to address bar.

http://www.seehere.com/zee/mitsu_pics

thanks again for your help. I really appreciated.

minnie · Posted: Mon Dec 08, 2008 8:37 pm Post subject:

The "bastard chassis"! The whole metal 'box' has to come out. The power supply is on the left, the rest of the boards are 'sandwiched" between. I HATE these.

zee · Posted: Sat Dec 06, 2008 5:21 am Post subject:

hi minnie

when I open the back of WD-62825 to change the caps on DM-board it is different than WS-73713. I have no clue where's the DM-board on WD-62825. I took some pics to show you if this is the board and, maybe you can also tell me how to remove this unit pls. cause, it looks very difficult. geeesh! I have another problem! can't seems to figure out how to upload pictures.

thank you for all you guys help

zee · Posted: Thu Dec 04, 2008 6:40 am Post subject:

thanks! ill let you guys know the outcome.

zee

minnie · Posted: Wed Dec 03, 2008 11:33 pm Post subject:

Power supply is 4 16@1000 and 2 10@3300's.

zee · Posted: Wed Dec 03, 2008 5:35 pm Post subject:

thanks minnie. so, I need to pull out the DM boards & replaced those 4 caps to 1000uf am i right? I've done this before w/ your help ( thank you again ) to an older tv. but I never changed the caps on a power supply. where's the p/s board be located? and, how many caps need to replace on the p/s? and what voltage?

thank you for your quick reply

zee

minnie · Posted: Wed Dec 03, 2008 5:27 am Post subject:

525's 625's 825's bad caps on the power supply and DM.

zee · Posted: Tue Dec 02, 2008 9:59 pm Post subject: Mitsu WD-62825

Hi guys,

quick question? after replacing a new bulb on wd62825 tv won't turn on anymore. blinking green lights. I've done reset button, unplug from the wall & recheck light bulb if its properly sitted and, still no go. is there any code from remote that need to put in to reset the tv. the timer is the one keeps blinking green light infront of the tv.

thanks in advanced

zee