 Posted: Thu Feb 25, 2010 6:47 am Post subject: Resolved |
|
| Problem fixed. Found several bad components in overload detect circuit. | |
| Posted: Mon Feb 08, 2010 1:05 am Post subject: |
|
| This Parts & Service manual can now be purchased for $10.77 and downloaded immediately after payment from http://www.justmanuals.com
[email protected] |
|
| Posted: Sun Feb 07, 2010 10:14 pm Post subject: Update |
|
| My error . . . I had the wrong button sequence for daig mode. Unit does power up as before, but I still have a protection error. I'll check things out again and post another update. | |
| Posted: Sun Feb 07, 2010 7:19 am Post subject: PIONEER VSX-818 |
|
| Hi All -
Here's another one that has me somewhat puzzled. I replaced the PAC014 amp module (which was defintely bad) on this like-brand-new VSX-818. Since doing so, I cannot get the silly thing to power up normally or diag mode, even with power replay bypassed. Prior to replacing the PAC014, I could power up in diag mode. The standby voltage is good. With power replay bypassed, all other voltages are good. I hate to think I zapped the CPU. Am I overlooking something obvious that's particular to these Pioneers' ? Thanks, Mike |
|