| Author |
Message |
| minnie |
 Posted: Sun Jul 04, 2010 11:43 pm Post subject: |
|
| Use electrolytics and bend the ends to fit on the pads. I've done hundreds of these. |
|
 |
| jts1957 |
| Posted: Fri Jun 18, 2010 2:28 am Post subject: |
|
Even IF you're sure that hyper board is the cause; and even if you use the best, most expensive replacement parts available; given enough time under the same conditions - they WILL eventually fail again.  |
|
|
| Guest |
| Posted: Fri Jun 18, 2010 12:57 am Post subject: |
|
| what materials do i need to recap the board something that wont break down again |
|
|
| jts1957 |
| Posted: Thu Jun 17, 2010 6:45 pm Post subject: |
|
| With these type sets you usually have convergence problems or it has a hyper board that needs recapping. Google model number + convergence (hyper). |
|
|
| Guest |
| Posted: Thu Jun 17, 2010 6:28 pm Post subject: |
|
was hoping someone could maybe tell me the parts that need to be replaced not just throw me a manual
i have looked up a few articles on this site and none of them seem to describe the same problem i have |
|
|
| jts1957 |
|
|
| Justmanuals |
|
|
| linkanthony |
| Posted: Thu Jun 17, 2010 4:06 pm Post subject: |
|
| p.s. can fix myself just need a push in the right direction |
|
|
| linkanthony |
| Posted: Thu Jun 17, 2010 3:59 pm Post subject: need help with a toshiba 42h81 |
|
have an old toshiba 42h81 and I usually use it to play my ps3.
When my ps3 is projecting in 1080i mode it works pretty good until i try to play a game then the screen becomes all fuzzy and distorted. also any 420p signal is distorted and 720p dosent display at all |
|
|