Canon 9000F Scanner

[canuck]

I am looking for service information or schematics for the 9000F scanner or the AC adapter used in this scanner (QK1-6242). I would like to find out what the voltage outputs of the 3 pin output connector should be. Any info would be appreciated.

[Pentode]

I have the 8800F and mines a flat three pin type affair, above the socket it's marked 32V.

I would imagine its a switch-mode type power supply, also keep in mind mine uses LED and not the CCFL back-light tubes. I would check above the socket just in case it's marked like mine.

If there is no output probably the wire has broken just as it goes into the molded part of the plug, also the switch-mode supply could be faulty.

That's the best I can do for now.

Dave

[Guest]

The best way is to use its guide book if not then search on google i hope you will fine something good according to your requirements.