error H4 sharp 5316 AR-Digital Copier

Maikle · Guest

Please can some1 kindly tell me how to cure a falshin error "H4" on the sharp AR5316??? I know its a sequence of buttons on the screen

Thank you

alpertevfik · Joined: 08 Jun 2006 Posts: 9

heater lamp&fuse ( broken heater)
RESET:clear -interrupt -0-interrupt
and 14 start-15 start
good luck
_________________
alp

alexglobal · Guest

Badereldin · Guest

Badereldin · Guest

Justmanuals · Joined: 21 Aug 2004 Posts: 1679

This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after payment from http://www.justmanuals.com

Paul@justmanuals.com
_________________
Want To Fix Something?
http://www.manuals4you.com

Need a manual now? Instant Download
http://www.justmanuals.com

Guest · Posted: Mon Feb 01, 2010 2:42 am Post subject:

Try the simulation about 5 times if not. u have to check fusing unit. so disconnect the two cables, turn it off then disconnect the power reconnect the cables.

Guest · Posted: Sat Feb 27, 2010 7:56 am Post subject:

H4 00 Content Heat roller low temperature detection
Detail When the fusing temperature is lower than
150C° after 55sec from the start of warming
up.
When the warming up complete temperature is
not reached in 30sec from reaching 150C°.
When the fusing temperature is lower than
100C° after 20sec from ready start.
When the fusing temperature is lower than
145C° when printing."
Cause Thermistor abnormality
Heater lamp abnormality
Thermostat abnormality
Control PWB abnormality
Check
and
remedy
Use SIM 5-02 to check the heater lamp blinking
operation.
When the lamp blinks normally.
Check the thermistor and its harness.
Check the thermistor input circuit on the control
PWB.
When the lamp does not light up.
Check for disconnection of the heater lamp and
the thermostat. Check the interlock switch.
Check the power PWB and the lamp control
circuit on the MCU PWB.
Use SIM 14 to clear the self diagnostic display.