PTK169 MISSING PARTS

[GESYMSB]

Hello folks, maybe some of you can help me with this.......

Someone give me a RCA PTV PTK169PK

The last tech that check it, remove some parts, I am trying to
at least get it going and see how bad is it.

I have gone up and down looking on the PTK169 Training
Manual and other places in the Web and they all show, what you
all know, the HV Splitter supply the Focus/Screen voltages to the
F/SCN Block, however, here is where the problem start.

On the PK, the "small" focus / screen controls block is connected
to a cable that comes from the side of the flyback, the HV Black
connnector on the tripler is connected to nothing, someone remove it
and also the "SIP" (small board on the Trippler).

On a PTK169 box that I got everything is connected as most schematics
shows or the training, Trippler to Scn/Focus Block and there is the SIP

So what is different with the 169PK ?

I cant find the regulator board on the PK, the Sip board normally
connect to there on all 169 that I have seen.

However, there are NO indications on the main board of the PK
of any missing HV Reg Board.

The thing that is driving me crazy is that the HV cable on the
169PK from the Focus/SCN block goes to the flyback and not
the Trippler, while both the 169 box that I got and this 169PK
uses a very similar Trippler if not the same.

Can someone have a scan of the connections between
the Flyback-HV Trippler - Regulator Board -Sip and Focus/Scn Block
for the PTK 169PK ?

Thanks.............. [email protected]