Yuraku LCD TFT Monitor MA9BBK

Desktop · Joined: 12 Dec 2007 Posts: 1

Advice for repairing dead monitor please ? Doesn't power-up, no response to On/Off button. Problem identified on main board, but any help/advice on identifying the faulty component most welcome.

Failed board has a number of identifiers : emax cpc51111r6242w pwr0501904014 r8215ama7a001 07041600454 e59670.

Yuraku LCD TFT Monitor MA9BBK

Adams Mustapha Ahodo · Guest

Please My monitor Doesn't power-up & doesnt response to On/Off button.
please what shd I do about it what component should I replace on the mother board

kobby · Guest

the number is R8215AMt4A001,its a power problem...how do i go about it?can you tell me the component to test...i am suspecting the diodeson yhe output..........regards ,Redeemer Kobina Biamco

timllfixit · Guest

I had one of these monitors that just died - no power led, no backlight, no display. Fault due to shorted (one of two in parallel) shotkky diode on 12v section of PSU board (supply to ccfl inverters) effectively shorting 12v output and killing pwm controller.

barknic · Joined: 17 Oct 2009 Posts: 1

timllfixit, Tim i have one of these monitors and am trying to repair it. Is it possible to tell me where to look for this fault? It does as you have mentioned. Nothing happens when try to power on. It worked fine for 18 months then one day died. I see you mention that the pwm controller is killed... is this something that can be revered? or should I throw monitor away.

THanks for your time

barknick · Guest

Hi... Just an update. It was one of the Schotty Diodes that was faulty. I measured the resistance of 4... 2 were shorting or were showing to be shorting so I removed one of them to test, just so happened that that was the faulty one. The monitor powered straight back up and has been working since. I will try locate one of the said diodes and install a new working on in the future. THanks for the suggestion Tim