zenith z50z83d8 convergence resistors burnt

[blazer]

zenith 50 inch tv blows 1 ohm resistors 4 of them replaced convergence ics but still burns resistor appreciate any help on this i seen the same problem in a earlier post a couple years ago in archives if someone has the answer would appreciate saving me the time of trouble shooting this the resistors are on the convegence board original problem was a high voltage trippler which replaced and brought back high voltage then found this problem
_________________
blazer tv repair tech

[minnie]

You did both IC's? And where did you get them?

[blazer]

local supplier they are sanyo not garbage have used them before from same supply
_________________
blazer tv repair tech

[minnie]

If it keeps blowing the resistors suspect a bad digital convergence unit or a bad ic. You should be able to order the whole convergence board rebuilt.
http://www.tvparts.com/