Author |
Message |
minnie |
Posted: Wed Aug 27, 2008 11:14 pm Post subject: |
|
HelpMyBigTV wrote: |
Fixed!
Not that it helps anyone but... I just replaced the bigger of the 2 boards. Clear pic w/ no more problems.
Thanks for all the help! |
I see you figured out which one was the flex converter! |
|
|
HelpMyBigTV |
Posted: Wed Aug 27, 2008 11:05 pm Post subject: |
|
Fixed!
Not that it helps anyone but... I just replaced the bigger of the 2 boards. Clear pic w/ no more problems.
Thanks for all the help! |
|
|
HelpMyBigTV |
Posted: Tue Aug 12, 2008 10:56 pm Post subject: |
|
Ok the only standing metal boxes are 2 tuners, 1 p in p module, and the convergence assembly. I know there is a flex converter but where? can you provide a picture?
Please Help!
Thank you! |
|
|
minnie |
Posted: Mon Aug 04, 2008 11:27 pm Post subject: |
|
It's a plug in board in a metal case. 4 prongs under the board that need to get unsoldered to remove the metal case. |
|
|
HelpMyBigTV |
Posted: Mon Aug 04, 2008 11:09 pm Post subject: |
|
So what does the flex converter look like? I have spare TV with a hole in the screen.. I figured I would just steal the parts.. any suggestions? |
|
|
minnie |
Posted: Wed Jul 30, 2008 3:15 pm Post subject: |
|
All video composite or component runs through the flex converter. The other suggestion was off of Hitachi's web site and I can't even find the other two parts. I would go with the flex converter. |
|
|
Guest |
Posted: Wed Jul 30, 2008 3:48 am Post subject: |
|
minnie wrote: |
Symptom: INTERMITTENTLY GOES OUT OF SYNC
Cause: DEFECTIVE IX01,XX02,XX03
Per Hitachi's web site.
Me personally, I'd say flex converter. #CS00185R |
Post a picture if you can. |
|
|
HelpMyBigTV |
Posted: Wed Jul 30, 2008 12:06 am Post subject: Location |
|
I found IX01.. do u know where the others are located?
and could you send me in the direction of a parts place?
I also noticed some of the parts say Sony,Toshiba, Zenith... cannibals? |
|
|
minnie |
Posted: Tue Jul 29, 2008 11:51 pm Post subject: |
|
Symptom: INTERMITTENTLY GOES OUT OF SYNC
Cause: DEFECTIVE IX01,XX02,XX03
Per Hitachi's web site.
Me personally, I'd say flex converter. #CS00185R |
|
|
HelpMyBigTV |
Posted: Tue Jul 29, 2008 11:43 pm Post subject: Hitachi 50" Projection Model# 50UX58B |
|
So I have a Hitachi 50" Projection Model# 50UX58B. You plug it in and it works fine, pic is great and then after a few minutes.. the pic starts to flicker and shrink and go crazy... the tv then shuts off and won't turn back on unless you unplug it and wait.. then start all over again. There is a way to avoid this.. a very slight and light tap on the base of the tv but this is only temporary.
opening the back reveals that all LED lights do light up, however when the pic goes crazy and shuts off, all lights extinguish.
this leads me to believe that there is a breaker in the system which is being tripped by an unknown problem at this point. Maybe something loose or slightly burned out which would require cleaning? I do not have schematics for this tv.. but does anyone really? So I don't know where to go from here...
I have checked c707 and e994 as other forums have suggested.. not the problem.
Help! |
|
|