Author |
Message |
minnie |
Posted: Sat Aug 23, 2008 5:46 pm Post subject: |
|
I can't read the print. It's not because of fluid. You're red convergence took a dump. Email the print. |
|
|
rf78801 |
|
|
rf78801 |
Posted: Sat Aug 23, 2008 1:06 pm Post subject: |
|
http://www.pechorin.com/m/2006/05/06/JVC_HV53PRO-261008.html (w/out the comma)....
Okay, thanks. Since it was shipped overseas, thought it might have leaked/dryed onboard the ship...but there would probably be some residue. Do you think the simo flicker of all three RBG bulbs indicates the power supply vs one of the resistors? |
|
|
minnie |
Posted: Fri Aug 22, 2008 6:27 pm Post subject: |
|
Link is bad but, if they were low on fluid, the whole inside of the TV would be wet. There should be 6 resisters. R/G/B vertical, R/G/B horizontal. Usualy around 1/3.3 ohm. |
|
|
rf78801 |
Posted: Fri Aug 22, 2008 5:23 pm Post subject: |
|
Will look for those part #s. How many bias resistors are there?
Also, ref this posting: www.pechorin.com/m/2006/05/06/JVC_HV53PRO-261008.html, describes a similar problem. Have you ever heard of these projection tubes needing fluid? How would one check to see if they are fully filled? I don't think that's the problem though as I've noticed that the tubes (all three) flicker irregularly every second or two. Problem affects all 3 tubes so I suspect it must be power related. Sound reasonable? |
|
|
minnie |
Posted: Tue Aug 19, 2008 8:13 pm Post subject: |
|
Look on the board. JVC usually puts the pert #'s on the board. |
|
|
rf78801 |
Posted: Tue Aug 19, 2008 6:01 pm Post subject: |
|
Hi Minnie. Sorry, all I have is the owners manual. Would it help if I emailed you a picture of the board?
Really appreciate your assistance, few options here. |
|
|
minnie |
Posted: Thu Aug 14, 2008 10:55 pm Post subject: |
|
I'd have to see the service manual. If you have it, email it to me. |
|
|
rf78801 |
Posted: Thu Aug 14, 2008 4:31 pm Post subject: |
|
Okay, thanks very much. Is the power supply you mentioned also on that board? |
|
|
minnie |
Posted: Wed Aug 13, 2008 6:00 pm Post subject: |
|
The board with the convergence IC's on it. |
|
|