| Author |
Message |
| janeedwards |
 Posted: Tue Dec 18, 2018 6:50 am Post subject: |
|
| Thanks for help! Now my reciever doesn't go into protection mode anymore! |
|
 |
| Guest |
| Posted: Tue May 08, 2018 6:40 am Post subject: |
|
| Thanks for the info, my Denon has these symptoms. |
|
|
| crossby |
| Posted: Sun May 06, 2018 9:38 am Post subject: |
|
We assume you installed new resistors for the ones that you clipped?
โหลด gclub
รูเล็ตออนไลน์ |
|
|
| Guest |
| Posted: Sat Apr 21, 2018 8:18 pm Post subject: |
|
| Your fix is still helping people out - I love that old Denon - THANKS! |
|
|
| Guest |
| Posted: Mon Aug 15, 2016 3:50 pm Post subject: |
|
Worked Perfectly!!
Thanks! |
|
|
| Gmcneil99 |
| Posted: Sat Dec 26, 2015 4:17 pm Post subject: Resistors 105 & 106 |
|
I just replaced resistors 105&106 and am happy to report that my trusty Denon is now working again.
Thanks |
|
|
| paulsaccount |
| Posted: Mon Nov 26, 2012 1:20 am Post subject: This solution worked! |
|
My DRA-685 was working until I was using it with headphones for a couple of hours with the speakers turned off. I turned it off the stereo for the night and tried to start it the next day, but as soon as it turned on it blasted some static noise, then turned on protection mode.
I tried the solution @vtech mentioned and it worked! I orderd the resistors from Parts Express.
Thanks!  |
|
|
| Box K |
| Posted: Fri Jan 13, 2012 8:39 pm Post subject: DRA-685 Protection |
|
| MY DRA-685 kicks into protection mode when the volumn is increased above 1/3 on the knob. This has happened since it was new. If I turn the volumn down, turn it off and back on again it works fine. I have checked all speakers and wiring. Is this resistor issue the same problem? |
|
|
| Guest |
| Posted: Thu Dec 09, 2010 2:08 am Post subject: |
|
| My DRA-685 was stuck in protection mode. I measured about 1V not 15V at the points noted. I ordered new resistors from Digi-key (last time was probably 25 years ago as a teenager!) and in 10 minutes had my receiver working again. Thanks so much!!!! Tom |
|
|
| Mattdubyou |
| Posted: Thu Dec 02, 2010 1:06 am Post subject: protection good, now on to output |
|
Thanks to Mitch & vtech for help with replacing the resistors. Now my reciever doesn't go into protection mode anymore!
However, now I just get a hum out of the left channel and barely any output from the right. I tried both A & B speakers and jumpers on the pre outs. Anyone had issues with this or have any suggestions? |
|
|