 Posted: Tue Jan 16, 2007 12:36 pm Post subject: |
|
| Only put the soldering iron on each cap for a few seconds and obviously remove it before you switch on. | |
| Posted: Tue Jan 16, 2007 12:07 pm Post subject: fault |
|
| C2523 6.8uf can cause this. Also thyristor 6641. Try putting a soldering iron on the end of each capacitor then switch on the set. This usually finds the culprit.
Allan |
|
| Posted: Tue Jan 16, 2007 2:32 am Post subject: Philips 21GR1366 (GR1AX Chassis) problem |
|
| The set trips immediately if turned "ON" in cold state. If the set is kept in Tripped state ( Supply ON, Set Tripped) for about 5-6 minutes and then it is turned "ON" the set operates perfectly. There is no other problem. I suspect some capacitor to be leaky. Kindly suggest remidial measures.
Regards, ashish1307. |
|