| Author |
Message |
| nimo_253 |
|
 |
| Guest |
 Posted: Tue Jan 30, 2007 1:20 pm Post subject: |
|
| minnie wrote: |
| If the Y sustain board failed again you can assume 2 things. Either you need to replace the power supply or the panel is bad. What did they give you for a reason that it blew again? |
The repairman said that the Y coupling was bad tried and replaced it. Then he was setting the convergence and the Y coupling blew again saying the Y Driver Board was the one that caused the blowout?
The guy is charging me $550 for the part upfront I already put a $130 deposit and $450 for the labor. |
|
|
| minnie |
| Posted: Sat Jan 27, 2007 7:08 pm Post subject: |
|
| If the Y sustain board failed again you can assume 2 things. Either you need to replace the power supply or the panel is bad. What did they give you for a reason that it blew again? |
|
|
| nimo_253 |
| Posted: Sat Jan 27, 2007 3:38 am Post subject: |
|
| I had got this monitor as a gift from this person I did work for back in 04' |
|
|
| minnie |
| Posted: Fri Jan 26, 2007 11:59 pm Post subject: |
|
| Sony's warranty or out of warranty? |
|
|
| Guest |
| Posted: Fri Jan 26, 2007 10:30 pm Post subject: Sony Plasma 50px1 - Problems |
|
| I had this monitor connected to my PC with a ATI Radeon X850 Video Card. I wanted to overclock the card with this software ATITools. I made adjustments with the core by underclocking below <300-200Mhz (was playing around) and a few seconds later something inside the monitor blew. So I took the monitor in for repairs and 4 months later they said that they fixed it but blew again saying that the "Y Driver Board" was bad? |
|
|