| Author |
Message |
| vtech |
|
 |
| Guest |
 Posted: Mon May 07, 2007 8:23 pm Post subject: Don't know capicator type Please help. |
|
| The Thermistor appears to look o.k looking at the pic. Remember as this is a Thermistor it will be hot to the touch. It has a resistance when cold and when the unit is switched on current flows through it and the resistance falls as the current causes the temperature to increase. |
|
|
| og style |
| Posted: Sun May 06, 2007 2:09 pm Post subject: |
|
| I am sorry I was talking about the numbers on the Thermistor |
|
|
| vtech |
|
|
| og style |
| Posted: Sun May 06, 2007 2:15 am Post subject: |
|
| Can you tell me how to read the numbers on the component. I need to order a new one. I did not use my head when I asked about the relay. I should have known about that. |
|
|
| vtech |
| Posted: Sun May 06, 2007 1:20 am Post subject: |
|
| No, a 24volt relay will not work in place of a 12 volt plus it must have the same switching/pinout. And the device in picture is definitley NOT a capacitor & infact IS a Thermistor. Can not recall exactly where, but have seen it used on other control circuit boards (ICL is a correct prefix) |
|
|
| Guest |
| Posted: Sat May 05, 2007 11:36 pm Post subject: Don't know capicator type Please help. |
|
| Looks like a Thermistor rather than a capacitor. |
|
|
| OGSTYLE |
| Posted: Sat May 05, 2007 6:44 pm Post subject: Don't know capicator type Please help. |
|
I am fixing a motor for a recliner chair. I think that a relay is fried. The one and only capicator on it is blown out. I am trying to figure out the info on this cap so I can replace it. The numbers on it are ICL12 10005. Please help me.
The relay this unit uses is a 812h-1c-c b12v would it be ok to use a rgtb-24vu in its place? |
|
|
