| Author |
Message |
| minnie |
 Posted: Sun Dec 16, 2007 11:54 pm Post subject: |
|
| You have to check them with a meter, looking won't tell you everything. They may look ok but their open. |
|
 |
| Litherish |
| Posted: Sun Dec 16, 2007 11:25 pm Post subject: |
|
| minnie wrote: | | Put new IC's in again and check F850 and F851 5 amp pico fuses, you may have toasted them if you solder blobbed. |
I checked F850 and F851, they both look good. I'll put the IC's back in and hopefully that will fix things... |
|
|
| minnie |
| Posted: Sat Dec 15, 2007 11:10 pm Post subject: |
|
| Put new IC's in again and check F850 and F851 5 amp pico fuses, you may have toasted them if you solder blobbed. |
|
|
| Guest |
| Posted: Sat Dec 15, 2007 1:09 am Post subject: |
|
| minnie wrote: | | Did you check the resistors? |
I checked them all, I couldn't see any discoloration or blisters.
The TV did work before I replaced the STKs, the color was just off, but now that I replaced the STKs it just keeps clicking. The job was a bit sloppy though, so I'm getting some desolder wick and doing it over. |
|
|
| minnie |
| Posted: Fri Dec 14, 2007 11:15 pm Post subject: |
|
| Did you check the resistors? |
|
|
| Litherish |
| Posted: Fri Dec 14, 2007 3:21 am Post subject: |
|
| I replaced the STKs with 150s, but when the TV is turned back on all I hear is a clicking noise from the left component board like it is trying to turn on? No picture or sound. |
|
|
| minnie |
| Posted: Thu Nov 29, 2007 11:24 pm Post subject: |
|
| 392-110's-392-150-392-180-394-160. All are good. |
|
|
| Litherish |
| Posted: Thu Nov 29, 2007 5:31 am Post subject: |
|
| I've got the same problem, this thread has shown me what I need to do. My only question is if it would be to my advantage to replace the STK392-110's with STK392-150's? |
|
|
| minnie |
| Posted: Sun Aug 05, 2007 5:35 pm Post subject: |
|
| The STK's blow the resistors when there bad. So there junk. |
|
|
| Richey |
| Posted: Sat Aug 04, 2007 9:56 pm Post subject: |
|
| Phils wrote: | You didn't need to replace the SDK amp just the resistor?
|
Unfortunately we had replaced the two STKs first and the TV was still doing the same thing. Then after closer inspection I found the bad resistor. The STKs may have been ok... ? Ah well, I kept them. |
|
|