| Author |
Message |
| blaydoncomms |
 Posted: Thu Jun 18, 2009 6:15 pm Post subject: |
|
We have repaired a couple of these the value of R1 is 10 ohm and we have just used a 0.25w metal film resistor. You also need to check and probably change C6 and C22 which are 220uf 25v Electrolytic Capacitors.
Hope this helps. |
|
 |
| Blaydoncomms |
| Posted: Thu Jun 18, 2009 12:40 pm Post subject: ACER Monitor Inverter Board |
|
We have repaired a couple of these the value of R1 is 10 ohm and we have just used a 0.25w metal film resistor. You also need to check and probably change C6 and C22 which are 220uf 25v Electrolytic Capacitors.
Hope this helps. |
|
|
| haxi |
|
|
| Guest |
| Posted: Sat Jan 31, 2009 7:06 pm Post subject: |
|
| Can you get the picture of the power board in the AL1711, I need the same picture of the resistor that the others are looking for. Very important. Thanks |
|
|
| 4ltrv1sm0 |
|
|
| jts1957 |
| Posted: Thu Jan 29, 2009 5:48 pm Post subject: |
|
| Doubtful. |
|
|
| 4ltrv1sm0 |
| Posted: Thu Jan 29, 2009 5:31 pm Post subject: |
|
Missed to login, sorry  |
|
|
| Guest |
| Posted: Thu Jan 29, 2009 5:29 pm Post subject: |
|
| Havent looked for it, can it fix issues like these? |
|
|
| jts1957 |
| Posted: Thu Jan 29, 2009 3:53 pm Post subject: |
|
| You have the service manual. It does not tell you how? |
|
|
| 4ltrv1sm0 |
| Posted: Thu Jan 29, 2009 3:43 pm Post subject: |
|
| By the way, how can I enter to factory mode? |
|
|