ElvisR |
Posted: Tue Oct 30, 2007 4:33 pm Post subject: |
|
Does pressing the power switch take it out of standby mode, but nothing happens? If so, it could be one of two things:
1. (most likely) one - if not both - of the main audio output hybrid ICs are defective; causing a shutdown. Before you check this, check #2.
2. The power transformer might be at fault. Check that output AC voltages are present on the secondary legs.
If #2 is OK, then remove one of the IC in #1 (as with most of these units, it may be a 2 IC system. It may be on a module that you can unplug - not sure for that model. After you remove one IC, power up unit and test. If it works, you know that IC alone is bad. If it does not power up, then remove the second (if more than one), and test again. It unit powers up fine. Then the IC is defective. If there were two ICs, put back the first one, and test again - to make sure that one is bad.
These ICs run about $50 each, so make sure both are bad.
Follow up please.
Elvis |
|