| Author |
Message |
| 445NDO |
 Posted: Sun Oct 11, 2009 1:54 am Post subject: |
|
| minnie wrote: |
STK394-160 replaces all the others. Thanks for the update  |
|
|
 |
| 445NDO |
| Posted: Sun Oct 11, 2009 1:53 am Post subject: Thanks for the update |
|
| minnie wrote: |
| STK394-160 replaces all the others. |
|
|
|
| minnie |
| Posted: Thu Oct 01, 2009 11:19 pm Post subject: |
|
| STK394-160 replaces all the others. |
|
|
| Juice83 |
| Posted: Thu Oct 01, 2009 1:37 am Post subject: |
|
| I noticed alot of people say their I.C. chips are stk392-110 or 150 or whatever...Why am I the only person that has stk394 in mine? While testing my resistors I noticed that my tv has been repaired before due to the fact that a resistor was soldered on the wires of the old one. Basically this dude cut the resistor off the wires (or whatever u call the two silver things that get soldered to the circuit board) and soldered the new one on so it sticks up about an inch higher than the others |
|
|
| Juice83 |
| Posted: Thu Oct 01, 2009 1:29 am Post subject: |
|
| jts1957 wrote: |
Take the value of the resistor - add 10% and subtract 10%. If the value you read falls within this range - resistor is good. Example: 100 ohm is good if reads anywhere between 90 and 110 ohms. 
I only used 10% as an example, yours may be 5%? |
thanks...both too high and too low means bad resistor |
|
|
| jts1957 |
| Posted: Tue Sep 29, 2009 7:37 am Post subject: |
|
Take the value of the resistor - add 10% and subtract 10%. If the value you read falls within this range - resistor is good. Example: 100 ohm is good if reads anywhere between 90 and 110 ohms.
I only used 10% as an example, yours may be 5%? |
|
|
| Juice83 |
| Posted: Mon Sep 28, 2009 11:30 pm Post subject: |
|
| minnie wrote: |
| RK42 ok, RK46 bad, RK58 ok, RK62 bad, RK50 bad, RK54 bad. It's called a catastrophic failure. Change the IC's and 4 resistors. |
how do u kno if they r bad? my multimeter is giving me a little bit higher reading than what they were supposed to have |
|
|
| Juice83 |
| Posted: Mon Sep 28, 2009 7:20 pm Post subject: Hitachi 51swx20b |
|
| have same problem with mine but I only have 2 stk394-160...havent tested my resistors yet |
|
|
| minnie |
| Posted: Sun Nov 25, 2007 9:39 pm Post subject: |
|
| Glad you got it going! |
|
|
| outlaw sst |
| Posted: Sat Nov 24, 2007 6:16 pm Post subject: |
|
| finally received all my parts yesterday ,shipping got screwed up . took about an hour to solder all the parts , everything works great . cmpalmer.blogspot.com has some good pics. thanks for taking the time to help minnie you are appreciated. |
|
|