| Author |
Message |
| joefire |
 Posted: Sat Mar 22, 2008 2:27 pm Post subject: Hitachi Projection T.V. |
|
| Minnie, Thankyou for your help, the flyback transformer was the problem! Because of this forum I was able to repair my big screen without huge expense. Thanks again |
|
 |
| Guest |
| Posted: Sun Mar 16, 2008 12:03 pm Post subject: Re: Hitachi Projection T.V. |
|
| joefire wrote: | | Hitachi 57twx20b no picture ,sound fine all leds are lit up not blinking I have service manual and started to check i902 at term 4 . Has anyone seen this problem? |
I have cures for this one!
[email protected] |
|
|
| joefire |
| Posted: Sat Mar 15, 2008 11:40 pm Post subject: Hitachi Projection T.V. |
|
| Minnie, I checked the flyback transformer your way then mine. I am going to confirm possible bad windings with my ohm meter tonight. Will let you all know later. |
|
|
| minnie |
| Posted: Sat Mar 08, 2008 6:59 pm Post subject: |
|
| Forget the ic for now. Unplug one of the leads from the splitter and listen for arching. The true why would be with a high voltage probe. |
|
|
| joefire |
| Posted: Sat Mar 08, 2008 5:15 pm Post subject: |
|
| yes I know where that part is, how do you test that and what about Iho1? |
|
|
| minnie |
| Posted: Sat Mar 08, 2008 4:38 pm Post subject: |
|
| The high voltage divider is the black thing with three leads going to each picture tube. |
|
|
| joefire |
| Posted: Sat Mar 08, 2008 12:56 pm Post subject: |
|
Minnie I checked voltages on IH01. Readings are as follows:1=10.08v,2=11.62v,3=0v,4=2.47v,5=1.59v,6=10.5v,7=0v,8=0v,9=.027v,10=.041v,11=.041v,12=4.94v,13=.055v,14=2.02v,15=4.9v,16=0v . This part looks like a prom from an automotive computer. According to a voltage table I have on page 77 of the manual, the voltages are way off. What do you think? |
|
|
| minnie |
| Posted: Fri Mar 07, 2008 4:09 pm Post subject: |
|
| CHECK IH01, HIGH VOLTAGE DRIVER |
|
|
| Guest |
| Posted: Fri Mar 07, 2008 5:02 am Post subject: |
|
| I don't think they are. This set was working fine , then picture blinked off for a second and then it cut out completely. Day later picture would stay on for aprox. 20 min. and cut out. The red led does not blink protection . I have been following flowchart for no raster . |
|
|
| minnie |
| Posted: Fri Mar 07, 2008 12:37 am Post subject: |
|
| Yes. The red blue green tubes. |
|
|