 Posted: Fri May 09, 2008 11:30 pm Post subject: |
|
| Behind the audio/video jack is a metal can, it will say MVPU14 on the top. The 4 legs from the bottom need to be unsoldered and that can removed. There are 11 caps that need to be replaced or you can send it to PTS. | |
| Posted: Fri May 09, 2008 11:25 pm Post subject: |
|
| Subject: MVPU14 Hyper Module Repair (23148024 / 23148024P / 23148024X)
Symptom: Multiple Symptoms may be experienced depending on which capacitor is faulty. The primary symptoms are jagged, digitized or pie crusting of the picture. The set may also be described with a poor sync condition. Corrective Action: Remove the MVUP14 Hyper Module from the TV chassis, remove the top shield and replace the 10uf, 16v capacitors using Part Number 24619040 as shown in Figure 1. It’s recommended that all of the capacitors identified in Figure 1 be replaced. (Note: These capacitors are low impedance surface mounted aluminum electrolytic capacitors. Care should be taken to avoid damaging the PCB while replacing these capacitors.) |
|
| Posted: Fri May 09, 2008 10:24 pm Post subject: Toshiba 50h72 picture problems |
|
| I just bought a used toshiba 50h72. The picture is "scrolling" to the side. When I first turn it on, it's real bad, but as the tv warms up, it gets a little better, but does not completely fix. What is the problem. What can I do so that I don't have to pay outrageously for it to be fixed? | |