 Posted: Thu May 20, 2010 9:05 pm Post subject: My ilo lct32ha36 takes for ever to come on |
|
| My ilo lct32ha36 will come on after i unplug it over an over again while holding the power buttion it willl flash gren an go off so i unplug it an plug it in after a while of doing this the green like stays on for a couple of secs an the speakers pop,so i unplug it an re plug it an the green light stays on an after about 15-20 mins it comes on.Why doesnt it jus come right on?is it my power supply or my inverter??? help ple | |
| Posted: Mon Aug 03, 2009 3:20 am Post subject: Did it work? |
|
| I recently had a similar problem with my iLo TV. Did this work for you? | |
| Posted: Fri Aug 08, 2008 4:22 am Post subject: |
|
| You need to replace the inverters/inverter. | |
| Posted: Thu Aug 07, 2008 11:56 pm Post subject: lct32ha36 |
|
| I scrapped a polaroid flm 323b lcd tv that had the same inverter board 1320b1-16a. Your board might have an open ballast transformer. I would be willing to sell you this board, it came out of a functioning tv.( the display panel was cracked.) | |
| Posted: Mon Jul 21, 2008 10:33 pm Post subject: |
|
| check the typing again ... pretty sure it will be a I320B1-16A not a 1320... Shop Jimmy has 2 of them .... |
|
| Posted: Mon Jul 14, 2008 12:05 am Post subject: |
|
| they dont have my inverter. if theres one like it on there does anybody think its possible if all the plugs are the same just to buy a close match and try it? or will it not work? heres a close match i found to mine. can someone compare for me. http://www.shopjimmy.com/showparts.cfm?item=139103&ps=1391&pn=3 |
|
| Posted: Sun Jul 13, 2008 5:52 pm Post subject: |
|
| http://www.shopjimmy.com/searchparts.cfm?make=ILO | |
| Posted: Sat Jul 12, 2008 3:59 am Post subject: ILO LCT32HA36 Inverter Issue |
|
| ILO LCT32HA36 32" LCD TV Basicly heres the deal. the tv turns on. get sound. but my inverter isnt turning on. i can take a drop light and see a picture on the tv. *All my caps look good on my power supply no bulging or leeking. *iv checked the voltage of all the wires coming out of the power supply. *I have a 24V plug that runs from the PSU to the inverter. it has the correct 24V voltage at the inverter. *the inveter on/off switch is getting 4.9V *the caps on the inverter are fine and are reading 24V on the inlet *on the tv board there is a red LED and it is off. kinda lost on what to try next. all my troubleshooting points to the inverter board. but that red LED being off has got me thinking it may be something else. if the inverter is what is bad does anybody know where i could get one of these? Power Supply is a MLT169B REV 1.2 Inverter is a CMO 1320B1-16A Tuner Board is a E3761-053020-3 has phillips on the tuner in/out jack box.   |
|