Author |
Message |
vtech |
Posted: Wed Feb 11, 2009 6:43 pm Post subject: |
|
Unless you have some experience with mixing boards, that is not something to tackle. You'd at least need some sort of schematic or (reverse engineer) just to be able to see what is going on. For example, in mixing board application in general, opamps tend to be suspect when the basics check out OK. Based on your description, while it may be a simple defect, you may have anything from a power supply issue to signal processing? It has to be diagnosed properly first. "replacing parts" is not going to be helpful. Doubt if you could get any block diagram or troubleshooting out of their main site. Have you tried contacting their service provider in SA? You may get a better response by going direct or even use their phone number. |
|
|
peterl |
Posted: Wed Feb 11, 2009 1:19 pm Post subject: midas venice 160 |
|
yes i have tried there source midas , i have already send info request no respond from them , they dont even have any thing on troubleshooting or a block diagram for midas venice 160 i would really appretiate your help fixing this problem |
|
|
jts1957 |
|
|
peterl |
Posted: Thu Feb 05, 2009 2:06 pm Post subject: midas venice 160 |
|
hi guys i have a midas venice 160 desk ,there main master fader is destorting and there is no output i have already change the fader but still same problem arise i would appretiate any help as i have strugle for alengthy period peterl |
|
|