| Author |
Message |
| minnie |
 Posted: Fri Feb 13, 2009 12:00 am Post subject: |
|
If it keeps blowing the resistors suspect a bad digital convergence unit or a bad ic. You should be able to order the whole convergence board rebuilt.
http://www.tvparts.com/ |
|
 |
| blazer |
| Posted: Thu Feb 12, 2009 10:30 pm Post subject: zenith convergence burnt res |
|
| local supplier they are sanyo not garbage have used them before from same supply |
|
|
| minnie |
| Posted: Thu Feb 12, 2009 9:28 pm Post subject: |
|
| You did both IC's? And where did you get them? |
|
|
| blazer |
| Posted: Thu Feb 12, 2009 2:37 am Post subject: zenith z50z83d8 convergence resistors burnt |
|
| zenith 50 inch tv blows 1 ohm resistors 4 of them replaced convergence ics but still burns resistor appreciate any help on this i seen the same problem in a earlier post a couple years ago in archives if someone has the answer would appreciate saving me the time of trouble shooting this the resistors are on the convegence board original problem was a high voltage trippler which replaced and brought back high voltage then found this problem |
|
|