 Posted: Fri Apr 02, 2010 2:56 am Post subject: Can you e-mail the schematics to me? |
|
| Can you e-mail the schematics to me? [email protected] or [email protected] tnx Help me plz |
|
| Posted: Wed Jan 23, 2008 3:42 am Post subject: |
|
| Since it's been 2years. I believe the problem has been solved. I'm facing the same problem here (pincushion distortion) with the same make/model (philips 107). I'd know what was the root cause. | |
| Posted: Sun Dec 18, 2005 5:07 am Post subject: |
|
| Can you e-mail the schematics to me? I'm facing a FOCUS problem on my 107S, I just opened the case, but the I already adjust the most accessible screws and nothing happens. Thanks a lot ! [email protected] |
|
| Posted: Wed Oct 19, 2005 7:12 am Post subject: |
|
 Have a close look at your soldered joints in the line op stage especially the ew driver and modulator-if you havent any visible dry joints you may have a board break- regards mike |
|
| Posted: Tue Oct 18, 2005 8:33 pm Post subject: Re: schematics |
|||
I only have 107s schematics   |
|||
| Posted: Tue Oct 18, 2005 7:02 pm Post subject: schematics |
|
| Hello, Could you send the schematics for the 109S philips monitor also to me My email is [email protected] Thanks in advance. |
|
| Posted: Thu Jun 23, 2005 11:24 pm Post subject: monitor |
|
| try to resolder the pincusion section even and also if thier is coil and small transformer solder it again sometimes the loss conection is on the pin inside the coil | |
| Posted: Thu Jun 23, 2005 3:26 pm Post subject: |
|
| Hi Mike Did you have a look at the 107S' schematics i sent to you ? ros3bud |
|
| Posted: Sat Jun 18, 2005 8:47 pm Post subject: |
|||
Thanks |
|||
| Posted: Sat Jun 18, 2005 12:02 pm Post subject: |
|
| ill have a look on monday when im back at the shop... regards mike |
|