 Posted: Sat Mar 21, 2009 6:05 am Post subject: |
|
| Multimeter = YES Measure resistance of resistors and compare to value written on them.
Desolder = YES Always desolder first, then remove old device, replace with new device and solder. Many "How to" videos on you tube. |
|
| Posted: Sat Mar 21, 2009 5:14 am Post subject: |
|
| Sorry for double posting but I just realized I need to pull this board out entirely and desolder the underside where those pins from the IC go in don't I? Argh. I am not electronically inclined. I might need a walkthrough here or a link to one if anyone has such a thing.
Thank you, Huxley |
|
| Posted: Sat Mar 21, 2009 4:34 am Post subject: |
|
| Hey again,
I have those IC's unscrewed but I'm having trouble actually REMOVING them from the board. I don't want to force it too much and risk breaking something-any suggestions you could provide to get those out? I haven't removed the heat sink because I see no obvious way to do this. I unscrewed the two obvious screws holding down the unit. I do not know where to go from here. Also, how do I check for open or changed value resistors in the area? I'm unsure of what you mean by that. Are we talking multimeter time here or is there some other check I should be doing? Thank you for your help, Huxley |
|
| Posted: Sat Mar 21, 2009 3:21 am Post subject: |
|
| When you have IC's pulled, check for open or changed value resistors in the same area.
Yes, flash focus should work again. |
|
| Posted: Sat Mar 21, 2009 2:17 am Post subject: |
|
| Hey Jts,
Thanks for the reply. Once they come in and I put them on, are there any procedures that I need to follow to get this convergence back to normal? Should the flash focus work afterwards? |
|
| Posted: Fri Mar 20, 2009 5:49 am Post subject: |
|
| As to where to obtain: here's two options
http://www.mcmelectronics.com/search.aspx?C=&K=STK392-150 http://www.partstore.com/Part/Sanyo/Sanyo/STK392150/New.aspx |
|
| Posted: Fri Mar 20, 2009 5:43 am Post subject: |
|
| The convergence IC's are on the "D" board. The D board is on the left hand side with the back off. They occupy the largest heat sink. | |
| Posted: Fri Mar 20, 2009 3:55 am Post subject: |
|
| Bump-little help anyone? | |
| Posted: Wed Mar 18, 2009 4:21 am Post subject: |
|
| Hey again all,
I took a picture of the back of the TV. Could someone please point out where the STK392-150's are and where I can purchase them? Also, a link on how to install them if one exists? Thanks for any help! -Huxley  |
|
| Posted: Thu Mar 12, 2009 11:52 pm Post subject: |
|
| I'm on my way out the door, but if I take a picture of the boards and post them, could you point to what is what? My knowledge of this TV is limited.
Thanks for the reply, Huxley |
|