vtech |
Posted: Sun Jul 26, 2009 5:58 am Post subject: |
|
Hiya Jesse,
Sounds like you had no luck finding your cable?
To get the whole unit, your best bet is Ebay or another Auction site and chances are probably slim at best.
As far as the cable, more likely it is a discontinued part but UED(in US) still shows it on their catalog and may be able to get it?.... may want to email them (if not done already)
http://www.unionel.com/ued/searchResults.jsp#
In finding anything generic, The cable length is not an issue, it has to be long enough to reach from connector to connector while the boards are in place and if any more, it can be tucked under . The pitch has to do with the connector in which it is hooked up to and its pattern (inline or staggered)
It is rather difficult but if you could measure between any two connectors inside the connector and the actual width of the pin, it will give you an idea......and worse comes to worst, you could always go w/direct 14 separate wires point-to point. |
|