 Posted: Wed Sep 30, 2009 9:13 pm Post subject: |
|
| It's a snap connector. The connector stays on the big board. Look at it you'll see tabs lift up on them or take a flat head screw driver and pry from under up. | |
| Posted: Wed Sep 30, 2009 8:40 pm Post subject: Master to slave inverter connection |
|
| Though I may be in over my head I am certain I can replace the two inverters on my Sharp Aquos...except for the connection between the two boards. Is this a pin connection or are we dealing with solder points I can't see? I am leary of pulling anything to hard to check the connection point without a little confidence builder. Thanks | |