Willem |
Posted: Sun Jan 10, 2010 9:47 pm Post subject: Command codes Relisys plasma |
|
I have a Relisys plasma 42", type RP42AB20(S) It had very dark picture so I replaced the Z sustain board. After that it worked again. The problem I have now is that the remote control is not working. I checked the hardware, followed the signal to the processor, and that is ok. This set has a serial RS232 connector. With the terminal program Docklight I can communicate with the set. This plasma is about the same as a philips BDS4241. In the philips manual there is a command to switch the remote off and on. When I try this the set does not reply with ACK. The serial commands however are different so it seems. Does anyone has the correct serial command code for this plasma. willem |
|