| Author |
Message |
| den88 |
 Posted: Sun Jan 15, 2017 5:53 pm Post subject: im having the same |
|
| im having the same trouble with an onkyo tx-sv535 no sound any ideas |
|
 |
| vtech |
| Posted: Mon Apr 26, 2010 3:40 am Post subject: |
|
| Check your email |
|
|
| jsnz2007 |
| Posted: Sun Apr 25, 2010 10:40 am Post subject: |
|
| Hi Im having the same trouble with an Onkyo tx sr 603 - no sound any ideas? |
|
|
| Daemon |
| Posted: Fri Apr 16, 2010 2:54 am Post subject: |
|
Thanks for that.
Very much appreciated |
|
|
| vtech |
| Posted: Fri Apr 16, 2010 2:39 am Post subject: |
|
| Check Your Email. |
|
|
| vtech |
| Posted: Thu Apr 15, 2010 3:13 am Post subject: |
|
| Ok, give me a day or two, let me find the document & check back. |
|
|
| Daemon |
| Posted: Thu Apr 15, 2010 2:54 am Post subject: Re: Onkyo TX-SR603 Amplifier |
|
[quote="vtech"]
| Daemon wrote: |
Hi
So in other words, you do not have any "monitor out"? am I right? |
Thats correct. I meant I can still browse through the menus etc on the amp but it doesn't output to the television. |
|
|
| vtech |
| Posted: Thu Apr 15, 2010 2:49 am Post subject: Re: Onkyo TX-SR603 Amplifier |
|
| Daemon wrote: |
Hi
My amplifier recently stopped outputting.
It is still powered up so it is not the output transistors.
I have tried after scouring the internet checking the fuses, doing a hard reset while holding the video 1 button in and also checked the board for burnt traces etc .
Can anyone steer me in the right direction as to what to check next?
The speaker level calibration still works and outputs static to the speakers but I cannot access the setup menu(cannot see it on screen) and no sound outputs either.
Thanks
Steve |
Been a while since I worked on a receiver; You mentioned no setup menu? So in other words, you do not have any "monitor out"? am I right? Reason I ask, there was some type of document in that regard that I'm sure I still have somewhere in my computer. |
|
|
| Justmanuals |
|
|
| Daemon |
| Posted: Wed Apr 14, 2010 10:39 pm Post subject: Onkyo TX-SR603 Amplifier |
|
Hi
My amplifier recently stopped outputting.
It is still powered up so it is not the output transistors.
I have tried after scouring the internet checking the fuses, doing a hard reset while holding the video 1 button in and also checked the board for burnt traces etc .
Can anyone steer me in the right direction as to what to check next?
The speaker level calibration still works and outputs static to the speakers but I cannot access the setup menu(cannot see it on screen) and no sound outputs either.
Thanks
Steve |
|
|