 Posted: Wed May 09, 2018 1:25 pm Post subject: |
|
| [S331B integrator fail Hi, who have more information about this problem ? My S331b has the same problem Where to change component ? Many thanks Michel] Hi my S331D works perfectly for a few minutes after a cold start and then fails the self test with Integrator Fail. Has anyone found a solution yet? Any schematics out there?? Thanks Deon[/quote] |
|
| Posted: Sun May 06, 2018 9:34 am Post subject: |
|
| I will try replacing the audio output ic but there are two of them. Should I replace both? จีคลับ คาสิโนออนไลน์ |
|
| Posted: Tue Oct 10, 2017 2:34 pm Post subject: S331B integrator fail |
|
| Hi, who have more information about this problem ? My S331b has the same problem Where to change component ? Many thanks Michel |
|
| Posted: Thu Jan 26, 2012 10:27 am Post subject: did you find the problem? |
|||
| did you find the problem? best regards, Leonid
|
|||
| Posted: Sat Jan 22, 2011 7:42 pm Post subject: |
|
| I have two S113's doing exactly the same - as indicated by bwal. The self test fails and the Integrator Failure appears and the temp if been on for a while can go up to 50 degrees on the display . Mine I have not used in two months and both are doing the same so I am confused. I have a trusty s112 but that does only >300 Mhz so I am in need of information on these units. Any schematics etc availible for them ? |
|
| Posted: Thu Jan 13, 2011 8:17 pm Post subject: S33x Integrator fault |
|
| The fault is probably NOT in the RF-input; Rather is it the VCO-step integrator, that have lost a bit or two in it's conversion Digital to Analog for the VCO-tuning 1- 21 Volt. Check the D/A ! Most often You can scan a narrow band segment (where the bits are working) with a good update time. When the bits are missing, the sweep takes a very long time (minutes per frequency step) and the response is totally flat.. GL |
|
| Posted: Fri Nov 26, 2010 1:21 pm Post subject: |
|
| I have noted that for many Anritsu instruments, some critical parts like input circuitry, mixers etc are not mentioned in the service manual although the rest of the instrument is very well documented. | |
| Posted: Fri Nov 19, 2010 4:09 am Post subject: Re: Anritsu / Wiltron S331B sitemaster integrator failure pr |
|
| I have the same problem with a S331A and S331B and can not find information, I hope someone can help. Greetings. Charles. |
|
| Posted: Sun Sep 12, 2010 12:02 am Post subject: Anritsu / Wiltron S331B sitemaster integrator failure proble |
|
| Does anyone have any info on the input layout, component part numbers, or schematic extract for the input port on Sitemaster analysers? I have been asked to look at an S331B which I guess has been overloaded, but none of the components look black or burnt - so any assistance would help. Cheers Michael |
|