View previous topic :: View next topic |
Author |
Message |
GO Guest
|
Posted: Thu Mar 10, 2005 7:05 am Post subject: SDP5075 PIONEER PROJECTION TV |
|
|
Unit tries to turn on but after 2-3 seconds turns off. Any ideas? |
|
Back to top |
|
|
Just Fishing Guest
|
Posted: Mon Mar 21, 2005 6:13 pm Post subject: |
|
|
Did you get this resolved? If so what was replaced? I'm experencing the same problem.
Thanks |
|
Back to top |
|
|
meto Guest
|
Posted: Sat Oct 01, 2005 8:16 pm Post subject: Same problem: Pioneer SD-P5075 - A great TV.. |
|
|
Our Pioneer SD-P5075 bit the dust.. Turns off immediately on power on sequence. Some chip problem, judging from other discussions on the IWAY |
|
Back to top |
|
|
Mega Guest
|
Posted: Tue Feb 21, 2006 9:35 pm Post subject: You have a short circuit |
|
|
all pioneer tv have a protection system that turn off, when a problem detectec. you must review the crt tubes sockets. Almost all tv pioneer start with these failure... good lock..
after your problem fixed, you will need to re-align the convergence memory, from service mode... maybe the new convergence and re-alignment manual could help you.. buy it at EBAY, search keywords "Tv repair alignment"...
Any other question: [email protected] |
|
Back to top |
|
|
mega Guest
|
Posted: Tue Feb 21, 2006 9:40 pm Post subject: DONT TRY TO START AGAIN THE TV AFTER PROBLEM FIXED |
|
|
DONT TRY TO START AGAIN THE TV AFTER PROBLEM FIXED
Because the eprom alignment memory could be totally errased... and STK chip could demaged..
If your tv turn off after start.. it have a circuit problem... a short circuit or loosing high voltage lead..
good luck..
any question: [email protected] |
|
Back to top |
|
|
Mega Guest
|
Posted: Tue Feb 21, 2006 9:43 pm Post subject: |
|
|
Dear Friends..
I am looking for a SD-P5075K or SD-P5075 service manual or diagram...
if somebody know anything..please contact to me...
Thanks...
[email protected] |
|
Back to top |
|
|
Davis0253 Guest
|
Posted: Sun Apr 05, 2009 4:56 am Post subject: Power problem |
|
|
just take back peg board off on bottom where power cord is inside you find chip boards find the two fuses that are next to each other take them out and switch them and put back in tv will work with no more problems |
|
Back to top |
|
|
Justmanuals
Joined: 21 Aug 2004 Posts: 1948
|
|
Back to top |
|
|
|
|