Toshiba TP61G60 61" rear projection

[Tdog2114]

History:
TV would power on then blink the LED on the front panel. Upon reading other forum "Convergence IC392-110=? NTE7178?", I replaced the Convergence ICs and the surrounding Resistors. One of the resistors for one of the IC was "well done". This corrected by POWER on issue.

The convergence is great for the BLUE and GREEN but... RED is horrible I performed the convergence procedure dictated by the SERVICE Manual. It improved the CENTERs (Vert and Horiz) BUT... the corners are bad (way off with a bit of a discontinuity at the edges).

Solution? Does anyone have any recommendations for correcting/improving the convergence in the corners.

[Guest]

You missed a resistor.

[minnie]

Does red move both horizontally and vertically? (left/right up/down)