Liteon Monitor Cable J15AAC / Fujitsu CTM5005

[Vym]

During a theft the integrated VGA cable was cut and the plug end stolen along with the base unit it was connected into. I'm now left with a potentially working monitor that I can't get a signal into.

If anyone has the same screen and has a screwdriver, a continuity tester and 20mins please help. I need to know which pins go to where, from the PCB connector "P306" in the monitor out to the standard VGA male D-sub plug.

The service manual is little help as are Liteon and Fujitsu-Siemens for supplying a replacement cable.

It would be a shame to scrap a monitor over something so minor.