TEAC AG-V8525 keeps flashing "PROTECT"

Jan · Guest

Anything I can do about this?

Thanks for any ideas![/code]

Jan · Guest

I'd delete it if I could!

Guest · Posted: Fri Aug 26, 2005 9:34 am Post subject:

i have the same issue, what did you do or find out?

absorbentgnome · Joined: 30 May 2005 Posts: 51 Location: Cardiff, UK

Protect mode occurs when an overcurrent situation is detected by the power supply in the amplifier. This will occur if you have shorted the speaker outputs, or if the amplifier is damaged or has failed.
If protect mode occurs without any connections to your speakers, then the amp is likely damaged. It is possible to repair if you have knowledge of electronics - if not you will have to take it to be repaired.

ekilpatrick1 · Guest

I'm Screwed then!!