electronics, repairs, service manuals and datasheets discussion community for the repairs professionals and technicians
FAQSearchMembersGroupsRegisterProfilePM'sLogin/Out
Schottky Rectifier Sub

 
Post new topic   Reply to topic    Electronic equipment repair and service manual search discussion Forum Index -> Equipment Repairs
View previous topic :: View next topic  
Author Message
Elvis R
Guest





PostPosted: Thu May 24, 2007 4:13 pm    Post subject: Schottky Rectifier Sub Reply with quote

I took out a shorted SB1060FCT - 10A, 60V Common-K Schottky Rectifier - from a LCD monitor. It is extremely hard to locate. So I am looking for subs.
I was looking at the datasheet for NTE6088. It seems to be a compatible sub.

Can someone look at the the datasheets for these two and let me know, if it will work. Thanks
Back to top
eddwhatley



Joined: 03 Apr 2007
Posts: 5

PostPosted: Thu May 24, 2007 10:38 pm    Post subject: Reply with quote

HEEEY Elvis...we thought you had left the arena !

That replacement unit is heftier in the current spec and the volt rating is adequate and is in a to-220 casing. Not sure if your original is in the TO-220 also or if it is the variant.....all plastic casing... with no exposed heatsinking metal...IF a heat sink is used.
Also you probably are not going to experience any switching speeds in excess of 100KHZ.... right...in considering its I RRM specs.

Nte unit:
so that this doesn't get bumped as spam...you type in the w w w dot preamble...and then :
nteinc.com/Web_pgs/Full_Wave.html

73's de Edd
Back to top
View user's profile Send private message
Elvis R
Guest





PostPosted: Fri May 25, 2007 1:13 pm    Post subject: Reply with quote

Hey thanks for the reply, and Yes, I am still here Smile

The part I want to replace is in a TO-220 casing, and it does carry exposed heat-sinking. I know the NTE6088 is a little over the specs, but I do not mind. I am primarily concerned with the switching specs; will the replacement cause any obvious electronic noises.

I ordered one to see how it works. It is in the secondary power supply circuit, and operates at around 14-16VDC, at about 3-5amps max. So I do not see any issue, just needed a second opinion.

Thanks
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Electronic equipment repair and service manual search discussion Forum Index -> Equipment Repairs All times are GMT
Page 1 of 1

 
Jump to:  
You can post new topics in this forum
You can reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


eServiceInfo on FB - Service Manuals Free Download - Service Diagrams

Free TV Schematics Download - HARDW.net - Pinout Master - Jabse Service Manual Search - Jabse.InK  - onTap.bg

SnimkiOt.com - Poblizo.com : пътешествия