daewoo l i1911mn

polaret · Joined: 23 Oct 2004 Posts: 90 Location: greece

I have this monitor and after 10-15 minutes the picture disapears at first flashing and then black when i reconnect the PC gives sign no signal
can any one help

Neil Kwyrer · Guest

There is a fault in your monitor- it could be anything- the point is that you are seeking a simple answer to a complicated question(as do many)- the bottom line is that experience & knowledge are needed to fix the fault- you don't have- find a good tv tech.

polaret · Joined: 23 Oct 2004 Posts: 90 Location: greece

I am a tv tech but i have never take that kind of monitor, with that kind of damage, i have change all the capasitor and the first problem solved that is the second one .
If someone have ever that kind of pro it could be usefull, thats why you make a post, we are not seeking for a smart guy but for smart answers

vtech · Joined: 08 May 2006 Posts: 1264 Location: USA

Not familiar with the specific monitor but , sounds like it may be a "thermal" issue? ---may be try using a component cooler on the circuit?

In general, the "no signal" message is triggered when there is no video synch detected &/or lost from the detection circuitry which can be inside of a signal process IC. Anything from a connection issue or malfunction in synch. processing can cause it. If you can find a schematic & scope the signal, should give you some ideas.

polaret · Joined: 23 Oct 2004 Posts: 90 Location: greece

Maybe i was not explicit , the problem is not that says <no signal> but the picture goes down (black)after flashing .
when the picture is black i disconnect the PC and appears <no signal> maybe some dry joints or proseccor internal fault ,but i have no diagram to seek for

vtech thanks anyway