hitachi 57twx20b convergence problem

[lofixxit]

I got this tv from my boss. he replaced the stk's with some cheap ass($5) ones and made the problem worse(only green was bad, now all colors bad). I replaced them again with new 160e's. I checked all pico-fuses too.
When I go into DCAM, everything works but the colors are bowtied and I can't move any of them. Any suggestions? I'm stumped on this one. I have repaired many hitachi's and am pretty familiar with them. Help!
Jim

[jts1957]

Any bias resistors bad?

[lofixxit]

If you mean the return resistors next to the stk's, no. They are all good and look brand new. I'm thinking maybe the stk's aren't getting their +(-) operating voltages. It acts like the stks aren't working. Is there a voltage regulator that creates the stk voltages? I think it's +(-)24V.

[jts1957]

Pull up the datasheet on the stk and check the +/- VCC pins?

[lofixxit]

My thoughts exactly, I found a datasheet for stk392-110.I think they are the same pinout.According to that it's pins 4&5 for + and - vcc. I'm gonna check that out tomorrow.
I pulled power and def boards out and checked all pico's again and rechecked my solder connections with the meter on contin. everything there checks good. hmmm.... Hey thanks alot for responding and helping me. I really want this tv to work, my old sony's blue and red tubes are going. This tv was in my boss' bedroom and doesn't have many hours on it. Thanks again.
Jim

[minnie]

Resister so I can send you a pdf for troubleshooting.

[lofixxit]

ok, I registered. Thank you for your help.
Jim

[plcnut]

here is a data sheet for the stk392-110/stk392-150 equivalent built by NTE: http://www.nteinc.com/specs/7100to7199/pdf/nte7178_81.pdf It should be enough to at least get your pinouts and voltage ratings. Regards, Jason