View previous topic :: View next topic |
Author |
Message |
licoicekid Guest
|
Posted: Wed Sep 30, 2009 8:40 pm Post subject: Master to slave inverter connection |
|
|
Though I may be in over my head I am certain I can replace the two inverters on my Sharp Aquos...except for the connection between the two boards. Is this a pin connection or are we dealing with solder points I can't see? I am leary of pulling anything to hard to check the connection point without a little confidence builder. Thanks |
|
Back to top |
|
|
minnie
Joined: 18 Aug 2005 Posts: 2880 Location: Hell
|
Posted: Wed Sep 30, 2009 9:13 pm Post subject: |
|
|
It's a snap connector. The connector stays on the big board. Look at it you'll see tabs lift up on them or take a flat head screw driver and pry from under up. |
|
Back to top |
|
|
|
|
|
You can post new topics in this forum You can reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
eServiceInfo on FB -
Service Manuals Free Download -
Service Diagrams
Free TV Schematics Download -
HARDW.net -
Pinout Master -
Jabse Service Manual Search -
Jabse.InK -
onTap.bg
SnimkiOt.com -
Poblizo.com : пътешествия
Latest Service Manuals :
8100b Fluke • download1 Pioneer • Б. Боровски и др. - Микропроцесори - уст • daewoo cp-002 Daewoo • DVP3120 philips • 657U Philips • std90n03l std90n03l-1 ST • 4350 HP • adverts University • •
|