| View previous topic :: View next topic |
| Author |
Message |
Guest
|
 Posted: Tue Jan 04, 2011 11:35 pm Post subject: Mitsubishi VS-5042 - No Color/Grey and White ghosting |
 |
|
I have a Mitsubishi 52” projection TV (approx 12 years old). Can only see a ghost image on the screen and no sound. It worked fine until a couple months ago, then the picture started coming and going. If I tapped the side of the TV, the picture would come back. Finally, it went completely out and now only a ghost image.
The images are blurry gray and white. I can watch a show, but images are gray and white, and a bit blurry, but no 3-D effect. No color at all, and no sound.
Any Ideas on where to start troubleshooting this? Any help would be greatly appreciated. |
|
| Back to top |
|
 |
rturner76
Joined: 04 Jan 2011
Posts: 4
|
| Posted: Tue Jan 04, 2011 11:49 pm Post subject: |
|
|
I posted this as a guest... but I no longer am! I have been utilizing this site fo r some time.  |
|
| Back to top |
|
|
rturner76
Joined: 04 Jan 2011
Posts: 4
|
| Posted: Sun Jan 09, 2011 2:06 am Post subject: |
|
|
| No thoughts??? |
|
| Back to top |
|
|
Guest
|
| Posted: Sun Jan 09, 2011 5:11 pm Post subject: |
|
|
Full make and model is always helpful.
If banging the TV cured the fault in its beginning stages, that points to dry-joints (or what the yanks call cold-joints). You need to look for any poor solder joints in the TV, or ask an engineer to look it over. |
|
| Back to top |
|
|
Guest
|
| Posted: Sun Jan 09, 2011 5:13 pm Post subject: |
|
|
| Resolder delay line DL302. |
|
| Back to top |
|
|
|
|
|
FAQ
