etching processes

[tech_kalon]

i used the pcb layout software but may problem is how to etch may work, pls any can give idea how cn i do this, is there chemical to be use what kind of chem. thank you

[gary]

about 30 years since i last made a pcb. if i remember right the solution you require to etch a copper clad board is ferric chloride, as to where to get it i have not got a clue.

[RFS]

Radio Shack has the supplies you need, Also Mid-States Electronic Supply.
Did you know..., A black 'Sharpie' permanent marker works just as well as an expensive 'Etch-off' pen!