|16-02-2010||well good news is i have had it on all morning and no problems thus far so my fingers are crossed i,m hoping casue it was outside so long it just had to warm up and dry up as i live in damp place thx to all that looked and if you have any ideas on why it |
|16-02-2010||Mitsubishi ws-65809 code 24||I'm looking for information on a code 24. Set will power on then off in a couple seconds. I've checked and replaced a couple of pico fuses, but now I'm stumped. I think it may have something to do with the flyback transformer. Can anyone confirm this |
|16-02-2010||Manual Request for JVC RC-X240||Hello,
I have JVC RC-X240 radio with a defective tuning knob. Does anyone have a service manual for this unit. I cannot figure out how to properly disassemble the unit to futher investigate the tuning setup assembly.
Thanks in advance|
|16-02-2010||[quote:38748f7c21="vtech"]In looking at your first set of pictures, apparently those are in fact rotary encoders which are completely different than standard potentiometers. (the microcontroller Atmega48 (U1) to the right of the controls is a solid proof)|
|16-02-2010||Hanspree 32'' Power Board.. Pls Help||Hi Guys..
I have a Hanspree JT01 32'' TV and is not switching on at all.
The power LED is off all the time.
This was working till last week but my child just dropped it on the floor and from that day, it didn't switch on.
|16-02-2010||You can get the JVC RC-X240 service manual at www.schematics.me|
|16-02-2010||If blowing F704, there is a load on either one of your +- 63 volt rails.
It normally points to the shorted outputs but you mentioned they check ok? It is possible that they may be shorted now? Unplug unit & check the resistance from either line to |
|17-02-2010||service manual for JVC BR-S378U||Does anyone have a PDF version of the service manual for a JVC BR-S378U unit? I have one with the idler belt popped off it and I can't figure out the routing to get the belt back on.
Thanks in advance....|
|17-02-2010||routing for idler belt in JVC BR-S378U||The belt appears to have popped off the idler on this VCR unit. The belt itself is intact, so something likely became stuck due to inuse.
I can't figure out the routing to get the belt back on. The belt seems more than double the size required to get|
|17-02-2010||24 is vertical protect. I'd go after the vertical IC.|
|17-02-2010||sharp aquos lc-32ad5e-bk||Hi all. I am looking for a schematic diagram for sharp aquos model lc-32ad5e-bk. Thanks.|
|17-02-2010||I'm scrolling through service manual and must have missed the vertical IC. Can you point me to the correct pcb to find that IC. Meanwhile I'll keep looking. Unless by chance, you know the number off the top of your head? Thanks again.|
|17-02-2010||Try adjusting the screen voltage on the flyback.|
|17-02-2010||SONY CFD-515.rar is available for download in that area...maybe it is the same?|
|17-02-2010||SONY TV Model: KV-K21MF1 Chassis & Schematic Diagram||Hi All,
Could you please send me SONY TV Model: KV-K21MF1 Chassis & Schematic Diagram which I need urgently, as the set is totally dead.
Thanks in advance.
Can mail me at firstname.lastname@example.org too.
|17-02-2010||This Parts & Service manual can now be purchased for $10.77 and downloaded immediately after payment from http://www.justmanuals.com
|17-02-2010||Phaser 850 Serv. Manual||V. thanks if u send me at email@example.com
|17-02-2010||You can get the Sharp LC-32AD5E-BK service manual and schematic diagram at www.schematics.me|