|28-02-2007||that box has no relays inside.you will find the relay in the power supply section,little black rectangular part with 12 v on top.usually the contacts burn on them if this is the fault the tv usually does not turn fully off.|
|28-02-2007||6112||Have the same problem.It blinks few times E000 and turnf off automaticly.It's not the fuse,have no idea what could be ...
Will apriciate ANY help about it.
|28-02-2007||need acer prisa 310 p scaner driver||help please....
I need driver for scaner acer prisa 310 P, any one can help me?|
|28-02-2007||start by posting the model number|
|28-02-2007||HOW DO I WIRE A KENWOOD KDC 3021 INTO A CLIO ????||I NEED TO KNOW WHAT WIRES GO WHERE.....
I KNOW THAT RED IS FOR THE IGNITION, AND BLACK FOR EARTH... BUT I HAVE A YELLOW WHICH ALSO SHOWS FOR IGNITION???? AND A BLUE AND WHITE FOR POWER???? IM LOST
CAN ANY ONE HELP ME PLEASE|
|28-02-2007||Hmm. today I turned the tv on even with the strange noises coming out, however they stopped after awhile but the speaker was still humming.
The "clicking" problem was not solved. Maybe I'll look at it in dark if I can see sparks, if I cannot, t|
|28-02-2007||BEKO 16228 NX|
|28-02-2007||rx-318 reciever||I have a jvc rx-318 reciever that when you turn on the power button the light on the volume button is the only thing that works.The relay clicks over,but nothingelse seems to happen.It keeps blowing the 125v 5a fuse that it takes.Other then that nothing s|
|28-02-2007||CHECK R717 1M OHM CONNECTED TO PIN 5 OF TEA2029C, CHECK R722 ALSO 1M OHM FOR OPEN CIRCUIT OR HIGH RESISTANCE|
|28-02-2007||Thanks for the help Gary, but I should of mentioned from the start that I know nothing about TVs. I took some photos of the TV innades, is it possible you could explain exactly what I should be doing? Let me know me if you need any more phots.
|28-02-2007||IN THE MIDDLE OF THE MAIN PCB IS A LARGE MULTI PIN IC, IT HAS TEA2029C WRITTEN ON IT, THE RESISTORS ARE OFF PIN NUMBER 5 AND IN THAT AREA, MEASURE THEM WITH A MULTIMETER OUT OF CIRCUIT AND REPLACE IF NECESSARY, BEWARE THERE ARE STILL HIGH VOLTAGES PRESENT|
|28-02-2007||Re: Philips FSQ Vision - Tuning and colour problem||[quote:870f4b264c="Anonymous"][quote:870f4b264c="coiki"]
hi! i just bought an old philips FSQ vision... and i was trying to set up my universal remote control but i just can't find the code!! do you know any code that might work??[/quote:870f4b264c]
|28-02-2007||Just letting you know that I have fixed my original problem with this TV. I remembered that I once dismantled a similar TV long time ago and kept the electronics from it, so I just replaced the horizontal drive board and no more clicking.
The sound hummi|
|28-02-2007||How do I tune my Goodmans TV (285NS(B)) without remote?||Hello all. I no longer have the remote controller for my Goodmans TV (285NS(B)), is it still possible to tune the channels?
Here's a photo of the selection options at the bottom of the TV, I've tried messing around with them to no avail. I have no idea|
|28-02-2007||panasonic tcolour tv model tx21 jtp3-chassis z-7||Hi there, can anyone help me please. I have this tv and when I switching it on , it works for few seconds and after that it is turning off by itself with the stand-by led blinking.|
|28-02-2007||help me!! stereo philips||hello.. i need the code stereo philips model 22dc347/62b chassis Nº rn347fy1037708
thnks :D [/img]|
|28-02-2007||Panasonic TX24A1D (TV-Brand) User Manual||Hi,
I need the user manual for the TV-Brand TX24A1D from Panasonic.
Could someone upload this, please?
Thanks for help
|28-02-2007||Sony offers now Oriss.ap.sony.com. And seems to be hard to get access to that site.|
|28-02-2007||sony kp53v25||I have a sony KP53V25. Same problem. Blinks but does not turn on.
I want to replace both convergence chips. I checked the prices on mcmonline and electronix.com. mcmonline has STK392-010 for $11.95 and electronix.com has $55.52. big difference. Do i nee|
|28-02-2007||esquema do cs 4025||caro amigo estou com um cs 4025 com a fonte de 2kv com problema eu gostaria de saber como consegui o esque
|01-03-2007||Re: Sony KP-53v25 wont turn on||[quote:192c3cc597="zrwizard"]My projection TV is a 1995 model Sony KP-53V25, Great TV up till yesterday.
You turn it on and the Standby light(red)usually just blinks once and turns off. Once an awhile it my blink twice and shut down. And sometimes a c|
|01-03-2007||It's the DCU. Digital convergence unit. It stores the data to keep the convergence aligned.|
The yellow wire is for the memory backup 12V and the blue and white is for a power aerial.
Hope this helps|
|01-03-2007||Are you sure its the bearings, as i had a similar problem with my first edition which i thought was the bearings but it turned out to be inside the drum, it turned out to be a bra wire that had gone through the drum but not the plastlic casing, so i took |
|01-03-2007||Also bad A/D program chip||I was wondering if you ever resolved this issue or if you were forced to give up?|
|01-03-2007||Same model Tv VS-5007R is doing the same problem as above, the C2A04 resistor has been changed and the C2046 will be changed tommorow when radio shack opens, the question is:
these resistors dont look inflated or damaged in any way, does that mean they|
|01-03-2007||you can also put the yellow and red wires together to make it easier to connect, how old is the sterio and your clio they should have the iso connections on them already.|
That looks like the av button to me it swiches the tv, from tv, scarts and the front av connectors which are the three phono connectors on the left hand side (red yellow and white), you will need a remote control to tune in you set im afraid i will|
|01-03-2007||NEED S.M FOR GESTETNER F 230 FAX||HELLO I NEED THE S.M FOR GESTETNER F 230 FAX OR RICOH 2210 L FAX.
PLEASE SEND IT MY MAIL,
|01-03-2007||empty toner ? f 230 Gestetner||HI,
IN GESTETNER F 230 FAX SHOWS THE TONER EMPTY I REFILL THE CARTRIDGE BUT STILL SHOW THE EMPTY TONER, HOW CAN I RESET THIS OR THE COUNTERS, RICOH 2210 L FAX IS THE SAME MODLE.|
|01-03-2007||You can look on ebay for your remote they have alot for sale yours is 285nsb but heres a link for the cheapest one i can find.
Hope this helps|
|01-03-2007||That is an obsolete part & seems hard to find.
BDent enterprises in Pennsylvania, USA shows it in stock
|01-03-2007||location||1st fuse towards the rear is blown on the board with convergence chips. i.e. location is F1602.|
|01-03-2007||Hi, no, still have a box of boards that need processors, blank processors and a programmer LOL
|01-03-2007||Hitachi TV Model:C29-F100||Can someone please help me with the circuit diagram of Hitchi TV Model: C29-F100.
The power supply side has blown and I am looking for equivilants for Transistor no. B1548A and diode: RS3Fs
Please email me on: firstname.lastname@example.org
|01-03-2007||Thanks for clearing that up. So, if the convergence box were to fail, would that only effect the convergence, or would that cause the protection circut to activate and make the TV not fully come on?
I'm trying to confirm that the convergence box is ba|
|01-03-2007||First things first - the problem was indeed a faulty line output transistor and dry joints, duly fixed with a minimum of fuss and a decent price.
(recommendation: TV Clinic in Worcester Park, London)
A hint in the direction of it being a relatively st|
|01-03-2007||JVC/NEC 42” plasma fault HELP PLEASE||Hi I have 2 jvc av42pd20es plasma TV’s which use a nec panel (NO. np42b2mf02 or 42nh-pdp-4).SET 1. The fault is when switched on you get a hiss sound and no picture. After trying a few times the screen lit up black with different color dots jumping around|
|01-03-2007||replace both stk392-110 ics and the 3.15 amp fuse and you will be ok.|
|01-03-2007||monitor inves p/n:EP577 image does`t apear correctly||hi!
Y have a problem with a inves monitor, the image doesn`t appear correctly, the monitor have a color strips up down, and y see the image, but in background?
any one can help me?
|01-03-2007||replace stk392||thanks... U said to replace both stk392-110. think you meant to say replace both stk392-010. right?
Questions is: Can I replace with STK392-010 [b:092f155848]Sanyo[/b:092f155848] brand instead of [b:092f155848]Sony[/b:092f155848] brand. I checked th|
|01-03-2007||Sorry for the bad english :) .
I also need a service manual for a LP720/730.
I'm most interested in the pinout of the cablewizard-connector - RS232 (serial). (firmware upgrade)
|01-03-2007||Toshiba 55H70 Died||I have a 55" Rear Projection Toshiba Theatre View Tv. Model = Toshiba 55H70. Last night the screen went black and the power light started blinking.The only way to stop the blinking light is to unplug the set. When I plug it in again, after about 30 |
|01-03-2007||Thanks but gives me nothing|
|01-03-2007||Help||Dear all, I got problem on photocopier canon IR1600 error 247 and please tell how to reset|
|01-03-2007||Toshiba 53h71 turn off and back on||Hi,
I fixed a 53h71 with a new stk 392-150. All works fine but now the tv turn off and on by itself. I found a service bulletin for the same problem but it's for a 50hx70 model... I must add a 47uF from QA01 pin 54 to gnd. Is it the same fix for a 53h|
|01-03-2007||Probably stk-392-110 need to be replace. It's convergeance ic. Check the big resistor too near of stk's.
|01-03-2007||I have the same Problem. Can anybody help me ?